Precautions for Customizing LED Line Lights

Manufacturers of authentic LED line lights utilize SMT chip technology, solder paste, and reflow soldering techniques for production. Hence, the solder points on the LED line lights are smooth, with minimal solder, extending in an arc from the FPC solder pad to the LED electrode. In contrast, counterfeit LED line lights have uneven amounts of solder at the solder points, with most solder feet covered by a single spot and varying degrees of solder spikes, indicative of typical hand soldering.

During rain, LED line lights can get water inside. The plug of the LED line light is a special type of plug that allows water in and out. After some time, the water dries up.

The diameter of water molecules in LED line lights is around 0.4MM, which is larger than the size of the capillaries it can pass through. The diameter of water molecules is slightly larger than that of gas molecules, which can pass through holes of 0.27-0.39 millimeters... The concepts of sealing and waterproofing the products are actually the same, though the focus differs. The key to waterproofing is to prevent ingress, avoiding the invasion, penetration, and flow of external water or steam media.

Installation of a transparent waterproof casing, using the entire casing for protection; adding sealing waterproof potting material (such as transparent epoxy resin or silicone, etc.).

For LED line light products, waterproof sealing must be done to ensure the normal use of the LED lights. If leaking or gas leakage is found, please stop using. After all, there will be a definite usage after changing the product. Impact.

There are two types of FPC copper and rolled copper. The copper foil of the clad copper board is protruding. If you observe closely, you can see it from the connection between the pad and the FPC. The copper is tightly connected to the FPC and can be bent freely without the solder pad falling off. Excessive bending of the clad copper board, solder pad falling off, and high temperature during repair can cause the solder pad to fall off.

LED line lights come with an instruction manual and a tape manual in the box, along with LED line light connectors or sockets; however, counterfeit LED line light packaging does not include these accessories, as some LED lines can be omitted by the manufacturers.

LED line lights can be used in many places, especially in some elegant locations. Linear lights are often used. The line light source in this rendering is designed to match the ceiling. Because many linear lights cannot be exposed outdoors without protective measures, such lights not only fail to bring a good decorative effect but also affect the overall design aesthetics. The choice of a white light source can better apply to corridor environments, adding lighting to rectangular corridors to ensure the safety of people's travel.